The Xiaomi Poco F1 was launched in August 2018 with a 6.18″ IPS LCD display with 1080×2246 pixels resolution quality along with Corning Gorilla Glass protection. It has the Snapdragon 845 processor, 6/8GB of RAM, 64/128/256GB of internal storage options. It packs a dual rear camera setup of 12MP+5MP lens with dual pixel PDAF, dual-LED flash, HDR, Panorama, etc. There is a 20MP selfie camera with all the major connectivity options or sensors. It also features a 4000mAh battery with 18W quick charging support. All the Poco F1 users can easily download the latest MIUI 184.108.40.206 Global Stable ROM with Android 10.
Currently, the Poco F1 is receiving the latest software update V220.127.116.11.QEJMIXM based on Android 10. It brings the February 2020 Security Patch that improves system security. To recall, the stable MIUI 11 (Android 10) update offers all the new goodies like system-wide dark mode, new wallpapers & icons, nature sounds, always-on display (AOD) mode, dynamic live wallpapers, gesture navigation, smart reply, Screen Management, Mi Doc Viewer, early earthquake warning, improved notification & status bar, Mi-Go smart travel assistant, and more.
Check OTA Update
You can manually check the software update on your device whether it’s available on your device or not. Head over to the device Settings –> About Phone –> Check for Software Update. The update will be rolled out globally in an incremental manner and it should take some time to appear on all the units. If in case, you’re not receiving the firmware OTA update, you can manually download & install the firmware update from the link below.
RootMyGalaxy.net is not responsible for any hardware/software issues that occur on your device(s) by following this guide. We are certain that the following guide is carefully written, avoiding any mistakes on our side. If you are unsure of the causalities that may occur if the procedure goes wrong, then please DO NOT proceed.
- Take a backup of all your data just to be on the safe side if any incident happens.
- USB Debugging must be enabled.
- Make sure that the device has more than 50% battery percentage.
- You will require a PC or Laptop and a USB cable.
Download MIUI 18.104.22.168 Firmware:
Poco F1 MIUI 22.214.171.124.zip Global Stable – Full Stock Recovery ROM
Guide to Install Poco F1 MIUI 126.96.36.199 Global Stable ROM
- Download the firmware file and save that in your device.
- Now follow the guide given below to install the ROM manually (follow the recovery ROM (zip) guide):
We hope that you’ve found this guide useful and successfully installed the latest February 2020 patch (Android 10) update on your Poco F1.